Universal high-capacity bending machines for the treatment of welded wire meshes
A mechanical, continuously adjustable set-up of three different bending angles up to 180¡ is possible by means of adjusting fingers supplied in series. The bending roll rail prevents damages of the welded wire mesh. This one can be adjusted quickly by means of a hand crank. The large volume bending beam guaranties exact bending angles.
Standard equipment
Continuously moveable bending cams with 30 mm mandrel diameter
Distance marked 100 mm and 150 mm
Centrally controlled locking system, geared motor and foot switch control
Special equipment
Continuously moveable bending cams with 45, 60 and 75 mm mandrel diameter for greater bending radii
Special bending cams for 50 mm welded wire mesh partition
Additional fingers make it possible to complete numerous further bending angle adjustments
Continuously moveable bending cams with 45, 60 and 75 mm mandrel diameter for greater bending radii
100 storeable basket variants each with 6 measuring length and bending angles
Switchover to manual control
Measuring length from 75 mm up to 1.500 mm
Program control by means of pin circuit type I including angle correction switch. By means of the program control up to six different bending angles can be preselected and called on demand
The bending angle can be readjusted by means of the correction switch. The program control is mounted in eye level.
Computer-controlled program control system type II with +/- angle correction. Possibility of preselection for 8 different bending angle inputs and 100 storable basket variants including switchover to manual control.
